Perform these steps on the machine used to connect the remote console.ĭterm AUR is a tiny serial communication program. See Users and groups#User groups for details. Otherwise you will need root's permission to make a connection: Note: Before making a connection, it is recommended to add your user to the uucp group. Making Connections Connect using a terminal emulator program Unless specified otherwise in the kernel command line, getty will be expecting 38400 bit/s baud rate, 8 data bits, no parity and one stop bit-times. For /dev/ttyS0 (COM1) that would be Enable the service to start it at boot. If you have not configured console= in kernel command line start rvice. The last specified console= will be set as /dev/console.Īt boot, systemd-getty-generator(8) will start a getty instance for each console specified in the kernel command line. Kernel's output can be sent to serial console by setting the console= kernel parameter. Read Syslinux Wiki:Config#SERIAL for the directive's options. The serial parameters are hardcoded to 8 bits, no parity and 1 stop bit. To enable serial console in Syslinux, edit syslinux.cfg and add SERIAL as the first directive in the configuration file.įor COM1 ( /dev/ttyS0) with baud rate of 115200 bit/s: REFInd supports serial console only in text mode. If no key is pressed, the boot menu will appear on whichever (serial or console) appears first in the terminal configuration line. Note: When the terminal -timeout=5 serial console line is added to your menu.lst, your boot sequence will now show a series of Press any key to continue messages. Read GRUB's manual on Using GRUB via a serial line and the serial command for detailed explanation of the available options.Įdit the GRUB Legacy configuration file /boot/grub/menu.lst and add these lines to the general area of the configuration: GRUB_SERIAL_COMMAND='serial -unit=0 -speed=115200' For COM1 ( /dev/ttyS0) with baud rate of 115200 bit/s: Next add the GRUB_SERIAL_COMMAND variable and set the options for the serial connection. When using GRUB with a generated grub.cfg, edit /etc/default/grub and enable serial input and output support: The configuration instructions below will enable boot loader menu selection, boot messages, and terminal forwarding to the serial console.Ĭonfigure console access on the target machine Boot loader GRUB The administering machine can be any Unix/Linux or Windows machine with a terminal emulator program (PuTTY or Minicom, for example).

Installation of Arch Linux is possible via the serial console as well.Ī basic environment for this scenario is two machines connected using a serial cable (9-pin connector cable). An Arch Linux machine can be configured for connections via the serial console port, which enables administration of a machine even if it has no keyboard, mouse, monitor, or network attached to it.

Minicom serial port command line